Loading The Roll Medium - GRAPHTEC CE3000-40 User Manual

Loading the Roll Medium

1
Step
Lower the media set lever to raise the push rollers.
2
Step
Place the roll medium on the roll-medium trays or stand stock rollers, and then pass the leading edge of
the medium from the back of the cutting plotter so it emerges from the front, while making sure to remove
any slack in the medium conveyance path.
3
Step
Pull the leading edge out of the front of the cutting plotter so that it completely covers the media sensor. If
the leading edge has been pulled out too far, turn the roll to adjust the length of the medium that is protrud-
ing.
CHECKPOINT
Load the medium so that it passes over the media sensor.
4
Step
Adjust the position of the left- and right-hand push rollers to suit the width of the roll medium.
Media sensor
2 – 6