GRAPHTEC CE3000-40 User Manual page 5

Safety Precautions (Continued)
Do not use or store the cutting plotter in a location exposed
to direct sunlight or the direct draft of an air conditioner or
heater.
• Such locations may impair the performance of the cutting plotter.
Do not use the cutting plotter in an excessively dusty or
humid location.
• Such locations may impair the performance of the cutting plotter.
Do not place any receptacle containing water or other fluid on
top of the cutting plotter.
• Fluid falling inside the cutting plotter may cause electric shock or
a fire hazard due to current leakage.
Do not use the cutting plotter in a location subject to
excessive mechanical vibration or electrical noise.
• Use in such locations may impair the performance of the cutting
plotter.
When disconnecting the power cord or interface cable, do not
pull on the cord/cable.
• Such action will damage the cord/cable, resulting in a fire hazard
or electric shock.
If water or foreign matter enters the cutting plotter,
discontinue use. Turn off the power and unplug the power
cord from the electrical socket.
• Use of the cutting plotter in such a condition may result in
electric shock or a fire hazard due to current leakage.
• Contact your sales representative or nearest Graphtec vendor
for repairs.
CAUTION
Prohibited
Prohibited
Avoid water
Beware of electric shock
Prohibited
Prohibited
Unplug the power
cord from the socket
iv