P/S Oil Pump And Bracket; Radiator And Cooling Fan Assembly - Mazda 121 Workshop Manual

INSTALLATION
& 6
A/C compressor (it equipped)
Install the fuC compressor.
Tightening torque:
37-s2 N.m (3.8-s.3 m-kg, 27-38 ft-lb)
P/S oil pump and bracket
lnstall the P/S oil oump and bracket.
Tightenlng torque:
37-52 N.m (3.8-5.3 m-kg, 27-38 ftlb)
Drive bell
1. lnstall the P/S and/or A/C drive belt.
2. Adjust the drive bell deflections. (Refer to page B-5.)
Radiator and cooling fan assembly
1. Install the radiator and cooling lan assembly.
Tighlening torque:
7.8-11 N.m (80-il0 cm-kg, 69-95 in-lb)
2. Tighten the AJC pipe bracket to the radiator.
Tightening torqle:
6.4-9.3 Nm (65-95 cm-kg, 56-82 in-lb)
3. Connect the uooer and lower radiator hoses.
Caution
. Poaltion the hose clamp in the orlginal location on
ihe hose, and aqueeze the claBp lightly wlth large
pllers tg ensure a good fit.
4. Connect the coolant reservoir hose.
5. Connect the cooling ian connector.
6. Connect the oil cooler hose. (Al'X)
E
01EoBXI5a
I J
.DLEF
IJLLEY COMPFI
B-91