Clutch Hub Assembly; Bearing Inner Race (1St), Pinion Gear, 1St Gear; Synchronizer Ring - Mazda 121 Workshop Manual

J
TRANSAXLE
Clutch hub assembly (sth)
Nole
. Remove the clulch hub assembly (sth) as lollows
ll necessary.
1- lnstall the SST as shown in the figure.
2. Remove the clutch hub assembly (sth) using a press
Bearlng inner race (lsl), pinion gear' l3l gear
Caullon
. Hold the shaft with one hand so that lt does not tall.
'1 . Set the SST to the 1st gear'
2. Remove the b€aring inner race with a suiiable pipe
Plpe diameter: 20mm (0'79 in)
Clutch hub assembly (lsu2nd), synchronizer ring
Note
. Remove the cluich hub assembly (15u2nd) as tol-
lows if necessary.
1.lnstall the SST as shown in the figure
2. Remove the clutch hub assembly (1s 2nd) using a press
J-26