Mazda 121 Workshop Manual page 73

ENGINE STAND MOUNTING
- F
A O
O
I
20mm (0.79 i
1 . lnstall the SST (arms) to the holes as shown in the figure,
and loosely tighten the SST (bolts).
2. Assemble the SST (botts and plale) in the specilied po-
sition.
3. Assemble the SST (nuls, hooks, and bolts)
4. Install the SST to the respective arms.
Note
. Adiust the SST Oolts) so that lea€ than 20mm (0.79
in) ol thread is exposed.
. Make the SsT (plate and arms) parallel by adiust-
Ing the SST (bolts and nuis).
5. Tighten the SST (bolts and nuts) to atfix the SST firmly.
6. Mount the engine on the SST (englne stand).
ji,--\
,.=r l-'
-
\ \ J ,
i e
u i
B-35