Mazda 121 Workshop Manual page 367

TRANSAXLE
J
@t@
@
Note
. Procedure work with a pull scale.
. Procedure 12 work wilh a torque wnench.
11. Turn the SST with a pull scale. Adjusi the SST (preload
adapter) until the specified preload.
Preload: 0.5--0.7 N.m (5-7.6 cm-kg, 4.3-6.6 inlb)
Puff scafe:500-760 g (17.7-26.8 ozl
12. Turnthe SST with atorquewrench. Adjust the SST (selec-
lor) with the bars until the specified preload is obtained.
Preload: 0.5-0.7 N.m (5-7.6 cm-kg, 4.3-6.6 In-lb)
13. Bemove the SST.
14. Measure the gap around the entire circumference of the
SST (seleqtor).
15. Select the proper adjustment shim(s) to be used for the
ditferential by referring to the table and selecting the shim
which is nearest (onthethick side) to the largest measured
clearance in the selector.
Adiustment shim lhickness:
16. Remove the SST (bolts).
17. Remove the transaxle case and the SST (collars).
'18. Remove the bearing outer race from the SST (selector).
Install the selected shim(s) and
transaxle case.
bearing outer race to the
't9
0-25 (0.010) 0.10 (0.004)
0.35 (0.014)
0.80 (0.031)
J-43