Mazda 121 Workshop Manual page 364

J
TRANSAXLE
d.F
\ i c
4. lnstall the transaxle case to the clutch housing and tighten
the bohs to the specified torque
Tiohteninq iorque:
ig-zs-Hm {i.s-z.s m-rs, 14-19 tt'lb)
5. Set the SST onto the primary shaft and measure the stad-
ing torque with a torque wrench
Sta inq torque:
o-ra7 N.m (o-15 m-kg, o-1oB fi-lb)
6. Remove the transaxle case and the bearing outer race'
7. lnstallthe shim removed during disassembly andthe bear'
ino outer race.
Caution
. Verifv thal the primary shatt can be turned by hand
atteriightenina lhe transaxle case bolts'
8. Usino the SST measure the starting torque with a torque
wren;h and select the proper shim if the stading torque is
greater than in SteP 4.
Caulion
. oo not use mote than two (2) shims.
Adlustment shim lhickness:
mm (in)
0.30 (0.011)
0.35 (0.013)
0.40 (0.016)
0.45 (0.0r8)
0.50 (0.020)
0.55 (0.021) 0.60 {0.023)
I
6
rA
\ ,1-
J-40