Adjustment Shim Selection; Adjustment Shim Thickness - Mazda 121 Workshop Manual

TRANSAXLE
J
0 30 (0.012)
I
0 40 (0.016)
|
0 50 10 0r9)
Adiustmeni shim selection
Select the shim(s) as follows.
Primary shaft assembly
1. Set the primary shaft assembly into the clutch housing.
2. Installthe transaxle case to the clutch housing and tighten
the bolts io the soecified torque.
Tightening torque;
19-26 N.m (1.9-2.6 m-kg, 14-19 ftlb)
3. l\4ount a dial indicalor to the transaxle hanoer and meas'
ure the primary shatl thrust clearance.
Clearance: 0-0.lmm (0-0.004 In)
Caution
. Do nol use more than three (3) shims.
4. Select the closesl shim on the thin side from the table tor
adiustment of the primary shatt.
Adiustmenl shim thickness:
Secondary shalt assembly
Caution
. Do nol install lhe secondary shafl shim.
. Apply petroleum ielly to prevent the shim llom fall-
ing when installinE ii.
1- Remove the transaxle case and install the proper adjust'
ment shim for the orimarv shafi.
2. lnstall the primary shaft gear assembly and the secondary
shaft gear assembly.
Do not install the secondary shaft shlm at this time.
3. Shifl the gears to 4th gear.
J-39