Accelerator Cable; Battery Duct, Battery Carrier, And Battery - Mazda 121 Workshop Manual

INSTALLATION
Accelerator cable
1. lnstall the accelerator cable
z. AOiust tne caUte oetlection by turning nut @
Deflection: l-3mm (0.04--'0.12 In)
Battery duct, battery car er, and battery
1. Install the battery duct.
2. Install the battery carrier.
Tlohtenlnq torque:
ig-zs
l.m (i.9-2.5 m-kg, l4-19 fl-|b)
3. Install the battery and the battery bracket.
Tiohtgnino torque:
i.s-s.5
N.m'(so-60 cm-kg, 26-52 inlb)
Air cleaner assembly
lnstall the air cleaner assembly
Undercover and slde cover
lnstall the undercover and side cover.
-YA
steDs After Installatlon
i. ii'tn" 6"si"J o-'l *i" drarned, lill with the specified amount and type of engine oil
(Refer to Section D.)
2. Fill the radiator with the specified amount and type of engine coolant'
{Reter to Section E.)
s..ii iil" to^""*|. oil;.s drained, fill with the specified amount and type of transaxle oil
(Reter to Sections J, K )
4. aonnect the negative battery cable
5. Start the engine and check the lollowing
{1) Enaine oil, transaxle oil and engine coolant leakage
izi tgnition timing. idle speed (Refer to page B-8)
(3) Operation ot emission control syslem
6. Perform a road test.
7. Recheck the engine oil and engine coolant levels.
B-92