Retaining Ring - Mazda 121 Workshop Manual

TRANSAXLE
J
Rstaining rlng
Cautlon
. Roplace the retalning ng ll removed.
1. Install the retaining ring.
2. Measure the clearance between the retainino
secondary shaft groove.
Clearance: 0-0.1mm (0-0.004 in)
ring and
3. ll not as specilied, select the proper retaining ring from the
chart below and install it.
Retaining ring thickness:
mm (in)
2.0 (0.079) | 2.1 {0.082) | 2.2 (0.086) | 2.3 (O.O9O) | 24 (0.094)
Clutch hub assembly (5th)
Install the clutch hub assembly onto the secondary shaft.
Note
. Installthe clutch hub assembly (sth) wilh a press
it necessary.
Bearlng Inner race (5th)
Cautlon
. Replace the bearlng Inner race it removed.
1. Support the lst gear of the secondary shaft and press the
bearing inner race on.
2. Installthe new bearing inner race usingthe SST and press,
as shown in the figure.
3. lvleasure the clearance between 1st gear and the pinion
gear.
Clearance: 0.22-0.62mm (0.008---{t.024 in)
Maximum: 0.57mm (0.025 in)
J-33