Clutch Cable; Shift Control Cable (Atx) - Mazda 121 Workshop Manual

INSTALLATION
Drlveshaft
1. Apply grease to the end ot the driveshaft.
Caulion
. When installing the drlveshaft, be caretul not to
damage lhe oil seal.
. After Installation, pull the front hub oulward to con-
lirm that the driveshalt is sequrely held bythe clip.
2 Fil a new clip and install the driveshaft.
3. Install the lower arm ball-joint 1o the knuckle, and tighten
the clinch bolt.
Tightening torque:
43-53 N.m (4.4-5.5 m-kg, 32-39 fl-lb)
Clutch cable
lnstall the clutch cable and check diffrection.
(Refer to Section H.)
Shlft control cable (ATx)
Install the shitt control cable to the transaxle.
Tightening torque:
6.9-11 N m (70-110 qm.kg, 6l-95 inlb)
Shift control rod (MTX)
Install the shift control rod to the transaxle.
Tightening torque:
'16-22 Nm (1.6-2.3 m-kg, 12-16 in-lb)
Extension bar (MTX)
Install the extension bar to the transaxle.
Tightening lorque:
3l-46 N.m (3.2-4.7 m-kg, 23-34 in-lb)
B-87