Mazda 121 Workshop Manual page 370

J
TRANSAXLE
Adlustment shim and tunnel (Primary shaft)
1. lnstail the tunnel into the transaxe case
Pipe diameter: 40mm (1.57 in)
2. Install the adjustment shim(s).
Oll seal (ditlerential)
Caution
. Apply transaxle oil to lhe outer clrcumGl€nce of the
oll seal.
lnstall the new oil seal with the SST.
Bearlng outer race (differential)
1. Instai the bearing outer race into the clutch housing-
2. After mounting the clutch housing onto the transaxle hang'
er, tap in the differential bearing outer races with a ham-
mer until it is flush with the end of the clutch housing
Pipe diameter: 59mm (2.32 in)
-4
r-J
lr_:
--\R
\
$,\o,-
\m#
4PY
J-46