Mazda 121 Workshop Manual page 378

J
TRANSAXLE
Retaining ring
1. lnstall the crank lever and install the crank lever shaft.
Caution
. Verify the in3talling a retalning ring 6urely.
. lnstal the groove of crank lever shalt to the diftereF
tlal end.
2. Install the new retaining ring.
3. Shift the gears to 3rd gear and hold the shift rod with one
hand so that it does nol fall.
Transaxle case assembly
Note
. Tighten lhe bolts to the specified torque.
1. Apply sealant and install the lransaxle case.
Caution
. When installing the transaxle case, install the en-
glne mount No.l.
2. lnstall the transaxle case to the clutch housing.
Tlghtening torque:
i9-26 N.m (1.9-2.6 m-kg, 14-19 ft-lb)
Plug, spring, steel ball
'1 . Apply sealant to the
Plugs.
2. Install the geel balls, springs and plugs
Tiqhtenlnq torque:
-20-2tN.m
i2.O-3.0 m-kg, 14-22 ftlb)
3. Contirm that the transaxle operates smoothly when shitted.
If not, reassembly the transaxle.
ENGINE MOUNT No.l
sp ng
Oiameter mm {in) Lensh mm (n)
@
7.2 lO.2A)
22.5 (0.89)
7.2 10.28)
33.2 (r.31)
o
7.2 /{0.28)
22.5 (0.89)
J-54