ASSEi'BLY
Oil Pan
1. Remove all foreign material from the contact surfaces.
2. Apply silicone sealant to the shaded areas shown in the
figure.
l
-/-= {. I
Qr)
3. Install new gaskets onto the oil pump body and the rear
cover with the proiections in the notches as shown in ihe
figure.
4. Apply a continuous bead of silicone sealant to the oil pan
along the inside of lhe bolt holes and overlap the ends.
5. Install the oil pan.
Tightening torque:
7.8-ti
N.m (80-110 cm-kg, 69-95 in-lb)
End Plale
Install the end plate.
Tightening torque:
7.8-ll N.m (80-ll0 sm-kg,69-95 inlb)
Flywheel (MTX)
1- Remove the sealant from the tlwheel bolt holes in the crank-
shaft and trom the flywheel bolts.
Cautlon
. lf all the previous sealant cannot be removed lrom
a bolt, replace the bolt,
. Do not apply sealant if a new bolt is used.
2. Set the flywheel onlo the crankshaft.
3. Apply sealant to the flywheel bolts and install them.
@
BM
B-69