Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 99

TABLE A-10
Error Message
Recursive symlink found
'symbolic_link_name'. Please
remove it.
swapctl SC_GETNSWP failed
(errno=errno_value)
Unable to find cwd
errno_value
Unable to find the cwd
errno_value
System Exploration Error Messages (Continued)
Probable Cause
The DR daemon found a symbolic
link as it walked the /dev and
/devices directories. Some
symbolic links create a recursive
loop. The DR daemon will not allow
the detachability test to pass if it
finds a symbolic link in one of these
directories.
The swapctl(2) system call failed.
This system call is used to determine
which disk partitions are in use as
swap space. The DR daemon will not
allow the detachability test to pass if
the use of swap partitions cannot be
determined.
The DR daemon could not save the
current working directory. The
daemon switches into the /dev and
/devices directories to produce the
real pathnames that correspond to
device drivers.
The DR daemon could not determine
the name of the driver directory. The
daemon switches into the /dev and
/devices directories to produce the
real pathnames that correspond to
device drivers.
Suggested Action
Remove the symbolic link so
that the test can be retried.
Analyze what caused this error
by using the errno_value, and try
to correct it. Use the swapctl(2)
man page and the errno_value to
determine why the command
failed. The DR daemon may
have encountered a resource
limit. If so, stop the daemon
then restart it. Also, check the
size of the DR daemon. it should
be between 300- and 400-Kbytes.
If it is not within this range, stop
the daemon then restart it. If you
cannot recover the domain from
this error or if symptoms of a
memory leak exist, report this
error to your Sun service
representative, providing as
much information from the
system logs as possible.
Determine what caused this
error by using the getcmd(3c)
man page and the errno_value,
then correct the error.
Determine what caused this
error by using the getcmd(3c)
man page and the errno_value,
then correct the error.
Appendix 83