Figure 3-3 Dynamic Reconfiguration Window With The Complete Button - Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual

9. Click the complete button.
DR - Attach Board
Attaching Board:
Information:
POST (level=16, verbose=20, -
hpost is complete.
obp_helper -H -m20
Board debut complete.
Reconfiguring domain mask registers.
Board attachment initiated successfully.
Ready to COMPLETE board attachment.
FIGURE 3-3
The complete operation normally takes less than one minute to finish. When it has
successfully completed, DR displays the following message:
Board attachment completed successfully
The system board resources—processors, memory, and I/O devices—are now
available to the operating system.
You can view the domain information about the newly attached board by using the
buttons (CPU, Memory, Device, and so forth), as described in "Viewing Domain
Information" on page 37.
Caution – Before you choose the reconfig button, be sure to read "Reconfiguration
After a DR Operation" on page 7.
10. Click the dismiss button.
The DR Attach operation is complete.
22 Sun Enterprise 10000 Dynamic Reconfiguration User Guide • February 2000
5 Target Domain:
cpu memory
complete
abort
Dynamic Reconfiguration Window With the complete Button
Dynamic Reconfiguration
xf2
0, 0020) execution time 2:52
H
System Information
device
dismiss
obp
unsafe
reconfig
help
properties
all