Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 68

Hide thumbs Also See for Sun Enterprise 10000 Dynamic:
Table of Contents

Advertisement

Memory Allocation Error Messages
The following table contains the memory allocation error messages that are sent to
the system logs and to the SSP applications. Although the list contains several error
messages, each of them describe one of two possible errors: ENOMEM or EAGAIN. All
of the ENOMEM errors have the same suggested action, as do the EAGAIN errors.
TABLE A-2
Error Message
DR Error: malloc
failed (add notnet
ap info)
errno_description
DR Error: malloc
failed
(alias_namelen)
errno_description
52
Sun Enterprise 10000 Dynamic Reconfiguration User Guide • February 2000
Memory Allocation Error Messages
Probable Cause
While it queried the system
information, the DR daemon could not
allocate enough memory for a
structure in which to return the
requested information. The daemon
may have encountered a resource
limit. If the DR daemon cannot allocate
memory, then it cannot continue to
work. The errno_description usually
describes an ENOMEM or EAGAIN error.
While it queried the system
information, the DR daemon could not
allocate enough memory for a
structure in which to return the
requested information. The daemon
may have encountered a resource
limit. If the DR daemon cannot allocate
memory, then it cannot continue to
work. The errno_description usually
describes an ENOMEM or EAGAIN error.
Suggested Action
First, check the size of the daemon by
using the ps(1) command. Normally,
the daemon uses about 300- to 400-
Kbytes of memory. If the daemon is
larger than the above memory sizes,
then it may have a memory leak. If it
does, you should report this problem.
An ENOMEM error means that the DR
daemon is in a state from which it
cannot recover. An EAGAIN error
means that the problem may have
been temporary. You can retry the
operation, which may succeed
eventually, or you may have to stop
and restart the daemon.
First, check the size of the daemon by
using the ps(1) command. Normally,
the daemon uses about 300- to 400-
Kbytes of memory. If the daemon is
larger than the above memory sizes,
then it may have a memory leak. If it
does, you should report this problem.
An ENOMEM error means that the DR
daemon is in a state from which it
cannot recover. An EAGAIN error
means that the problem may have
been temporary. You can retry the
operation, which may succeed
eventually, or you may have to stop
and restart the daemon.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sun Enterprise 10000 Dynamic and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents