Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 105

TABLE A-10
Error Message
DR Error: device tree not
built.
DR Error:
dr_get_partn_cpus: cannot
get cpu's partition . . .
errno_description
DR Error:
dr_get_partn_cpus: failed
to get cpu partition info
. . . errno_description
DR Error: dr_page_to_kb:
page size smaller than a
KB
DR Error:
get_board_config: invalid
board state
System Exploration Error Messages (Continued)
Probable Cause
The libdevinfo API failed to build
the device tree for the system board.
More detailed information about this
error accompanies the error message.
The DR daemon tried to use the
pset_assign(2) function, but the
function failed. The DR daemon uses
this function to obtain the processor
set and partitioning information,
which it sends to the CPU
Configuration window.
The DR daemon tried to use the
pset_info(2) function, but the
function failed. The DR daemon uses
this function to obtain the processor
set and partitioning information,
which it sends to the CPU
Configuration window.
A math error occured, or an incorrect
memory value was used in a
memory calculation.
A communication protocol has been
breached over the eligibility of a
board. To the SSP, the board is part of
the domain. However, to the DR
daemon and driver, the board is not
part of the domain.
Suggested Action
Make sure that the correct
version of the libdevinfo is
included on the domain and that
a version mismatch does not
exist between the DR daemon's
libraries, the operating
environment on the domain, or
the DR daemon itself. If no
cause can be found, report this
error to your Sun service
representative.
Use the pset_assign(2) man
page and the errno_description to
determine and correct the cause
of this error.
Use the pset_info(2) man
page and the errno_description to
determine and correct the causse
of this error.
Report this error to your Sun
service representative.
Stop and start the DR
application, then retry the
operation. If the error persists,
use the kill(1M) command to
stop the DR daemon, then start
the DR daemon and retry the
DR operation.
Appendix 89