Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 106

TABLE A-10
Error Message
DR Error:
get_board_config: invalid
flag
DR Error: libdevinfo
failed.
get_cpu_info: cpu state
info is incomplete [non-
fatal].
90 Sun Enterprise 10000 Dynamic Reconfiguration User Guide • February 2000
System Exploration Error Messages (Continued)
Probable Cause
The SSP passed an invalid or
unsupported flag to the DR daemon
when the daemon tried to ascertain
the configuration of a board.
The initial routine used to open the
libdevinfo API failed, so the DR
daemon could not explore the device
tree for that board. The libdevinfo
API builds a tree of dev-info nodes
for a board as part of the DR
daemon's exploration of the domain
devices and their usage. The tree is
required by AP and DR operations to
test the detachability of a board I/O
devices. It is also used to inform the
user of what devices are on what
system boards.
The DR daemon could not gather the
states of the CPUs (either online or
offline). Therefore, the information
about each CPU in the CPU
Configuration window will not be
accurate.
Suggested Action
Make sure that the version
numbers match for the SSP and
the DR daemon. Also, check the
size of the daemon by using the
ps(1) command. Normally, the
daemon uses about 300- to 400-
Kbytes of memory. If the
daemon has grown far beyond
the above memory sizes, then an
internal error may have occur
within it. You may have to stop
and restart the DR daemon to
recover from this error.
Make sure that the correct
version of the libdevinfo is
included on the domain and that
a version mismatch does not
exist between the DR daemon's
libraries, the operating
environment on the domain, or
the DR daemon itself. If no
cause can be found, report this
error to your Sun service
provider.
None