Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 66

"DR Daemon Start-Up Errors" on page 50
"Memory Allocation Error Messages" on page 52
"DR Driver Failures" on page 59
"PSM Error Messages" on page 61
"General Failures" on page 63
"Protocol and Communication Error Messages" on page 65
"Attach-Related Failures" on page 70
"Detach-Related Error Messages" on page 72
"Auto-Configuration Error Messages" on page 77
"System Exploration Error Messages" on page 79
"OpenBoot PROM Error Messages" on page 93
"Unsafe-Device Query Failures" on page 96
"AP-Related Error Messages" on page 98
DR Daemon Start-Up Errors
The following table contains a list of the DR daemon start-up errors. These messages
are sent only to the domain console window.
TABLE A-1
Error Message
Cannot create server
handle
50 Sun Enterprise 10000 Dynamic Reconfiguration User Guide • February 2000
DR Daemon Start-Up Error Messages
Probable Cause
The DR daemon could not start up the
RPC server. You will see this message
only if you manually execute the DR
daemon without properly configuring
the network services on the domain.
Normally, network services spawn the
DR daemon in response to an
incoming RPC from the SSP.
Suggested Action
On the domain, fix the inetd.conf
entry for the DR daemon.