Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 67

TABLE A-1
Error Message
Cannot fork: descriptive
message
Permission denied
Unable to register
(300326, 4)
Unable to create
(300326, 4) for
netpath
DR Daemon Start-Up Error Messages
Probable Cause
The DR daemon could not fork a
process from which to run its RPC
server.
A user other than root tried to run the
DR daemon.
The DR daemon was executed without
being properly registered with the
network services in the domain. The
first number represents the RPC
number that is registered for the DR
daemon. The second number
represents the RPC version used by the
DR daemon.
The DR daemon was executed without
being properly registered with the
network services in the domain. The
first number represents the RPC
number that is registered for the DR
daemon. The second number
represents the RPC version used by the
DR daemon.
Suggested Action
The descriptive error message
corresponds to an errno_value and
offers clues as to why the DR daemon
could not fork off the RPC server.
Check the resource limits and the load
of the system to find a way to fix this
error.
Only the superuser (root) can run the
DR daemon because the daemon needs
all of the root privileges to fully
explore the system and to access the
driver to detach and attach boards.
On the domain, fix the inetd.conf
entry for the DR daemon.
On the domain, fix the inetd.conf
entry for the DR daemon.
Appendix 51