Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual page 85

TABLE A-6
Error Message
DR Error: get_cpu_info:
invalid board number
This error message is sent to the
system logs and to the SSP
applications.
DR Error:
get_obp_board_config:
invalid board number
This error message is sent to the
system logs and to the SSP
applications.
DR Error:
initiate_attach_board:
invalid board number
This error message is sent to the
system logs and to the SSP
applications.
Protocol and Communication Failure Error Messages (Continued)
Probable Cause
The RPC is attempting to perform a
DR operation on a board number that
is not in the range of valid numbers.
The DR applications carefully filter the
user input to catch out-of-range board
numbers before they send the RPC.
Therefore, this error indicates a
breakdown on the SSP or in the
network connection to the SSP. Or, it
indicates an incompatibility between
the SSP applications and the DR
daemon.
The RPC is attempting to perform a
DR operation on a board number that
is not in the range of valid numbers.
The DR applications carefully filter the
user input to catch out-of-range board
numbers before they send the RPC.
Therefore, this error indicates a
breakdown on the SSP or in the
network connection to the SSP. Or, it
indicates an incompatibility between
the SSP applications and the DR
daemon.
The RPC is attempting to perform a
DR operation on a board number that
is not in the range of valid numbers.
The DR applications carefully filter the
user input to catch out-of-range board
numbers before they send the RPC.
Therefore, this error indicates a
breakdown on the SSP or in the
network connection to the SSP. Or, it
indicates an incompatibility between
the SSP applications and the DR
daemon.
Suggested Action
Check the SSP network
connection and/or the SSP
and DR applications to
ensure that they are
operating properly.
Check the SSP network
connection and/or the SSP
and DR applications to
ensure that they are
operating properly.
Check the SSP network
connection and/or the SSP
and DR applications to
ensure that they are
operating properly.
Appendix 69