TABLE A-13
Error Message
Cannot find physical device
for AP_alias
This error message is sent only to
the system logs.
create_ap_net_leaf:
interface instance not
found
dr_ap_notify: unknown state
state_number
dr_daemon operating in NO
AP interaction mode
init_ap_rpc: Unable to get
hostname
AP-Related Error Messages (Continued)
Probable Cause
The physical device name that
corresponds with the AP alias could
not be found. AP may be confused
about the device name, or the /dev
and /devices directories are
incomplete.
The DR daemon tries to match the AP
metanetwork interfaces with the
physical device they represent. This
error indicates that the DR daemon
could not successfully match a
network interface with the physical
device it represents for this board.
The DR daemon called one of its
internal functions with a bad value.
However, this error is indicative of a
more serious problem.
The AP software is not working, or it
is not installed. This message means
that the DR daemon will not notify AP
about attach and detach operations.
The uname(2) system call returned a
null hostname. Consequently, the DR
daemon could not establish a
connection to the AP librarian.
Suggested Action
Make sure that AP works
properly. Check to see if all of
the device entries are present
in the /dev and
/devices directories. If they
are not present, add them the
to the appropriate directories.
Make sure that AP works
properly if you observe
abnormal behavior regarding
the availability of devices
during and after DR
operations. If this error
persists, report it to your Sun
service representative with as
much information from the
system logs as possible.
Report this error to your Sun
service representative with as
much information as possible
from the system logs.
Ignore this error if you do not
have AP installed. If it is
installed, make sure that it is
properly installed and that
the AP software version is
compatible with the version
of the DR daemon that is
running in the domain.
None
Appendix
99
Need help?
Do you have a question about the Sun Enterprise 10000 Dynamic and is the answer not in the manual?