TABLE A-8
Error Message
DR Error: detach_board:
invalid board state
DR Error: detach_finished:
invalid board state
DR Error: detachable_board:
invalid board state
DR Error: detaching board
would leave no online CPUs
Detach-Related Failure Error Messages (Continued)
Probable Cause
The proper sequence of board states
has not been followed, meaning that
the board went into the error state or
that an earlier failure in the drain-
detach sequence of events was not
properly reported.
Communication protocol has been
breached over the eligibility of a
board. To the SSP, the board has been
detached. However, to the DR driver
and daemon, the board has not been
detached from the domain.
Communication protocol has been
breached over the eligibility of a
board. To the SSP, the board is part of
the domain, so the SSP attempts to
drain the resources. However, to the
DR driver and daemon, the board is
not part of the domain.
The Detach operation failed because
no CPUs would be left online after the
board is detached.
Suggested Action
Examine the state of the board
by using the
dr_cmd_board_states(?)
command, and determine the
cause of the problem. Retry the
Drain and/or Complete-
Detach operations to
determine if the error is
recoverable. Stop and start the
DR daemon and driver.
Examine the state of the board
by using the
dr_cmd_board_states(?)
command, and determine the
cause of the problem. Retry the
Drain and/or Complete-
Detach operations to
determine if the error is
recoverable. Stop and start the
DR daemon and driver.
Examine the state of the board
by using the
dr_cmd_board_states(?)
command, and determine the
cause of the problem. Retry the
Drain and/or Complete-
Detach operations to
determine if the error is
recoverable. Stop and start the
DR daemon and driver.
Bring more CPUs online on
other boards in the domain, or
add more boards with online
CPUs to the domain, so that
the domain will have enough
online CPUs after the board is
detached.
Appendix
75
Need help?
Do you have a question about the Sun Enterprise 10000 Dynamic and is the answer not in the manual?