To View Domain Information With Hostview; To Specify How Windows Are Updated; Figure 3-6 System Information Buttons - Sun Microsystems Sun Enterprise 10000 Dynamic Reconfiguration User Manual

Note – You should view and use the domain information before you attempt to drain
the memory on the board.
The informational content is the same for both dr(1M) and Hostview. Note that the
cpu, memory, and device displays are only enabled when the board is attached to
the operating environment. When the cpu, memory, and device displays are
available, they always contain accurate information. The obp display shows the
information known to OBP, but it is not as detailed as the other three displays. This
section shows how to use the displays.

To View Domain Information with Hostview

Click on any of the System Info buttons during the DR operation ( ).
FIGURE 3-6
System Info
cpu memory device obp all
unsafe
System Information Buttons
FIGURE 3-6
When you click any of these buttons, a window is displayed, and it remains open
until you click the dismiss button within that window.
If you click the All button, all of the currently enabled windows are displayed.

To Specify How Windows Are Updated

1. Click the Properties button in the Dynamic Reconfiguration window ( ).
FIGURE 3-7
38 Sun Enterprise 10000 Dynamic Reconfiguration User Guide • February 2000