Beeper Callback No. Entry Mode; Device Notification For Unreceived Message - Panasonic KX-TVA50 Programming Manual

Beeper Callback No. Entry Mode

This feature allows a caller to dial his or her own telephone number, which the VPS then sends to the
subscriber's beeper.
Note
•
To use this feature, the callback number entry code "X" must be programmed along with the
subscriber's beeper number. If the caller does not enter a callback number, or if this feature is set to
"Disable", the "System Callback No." (set in "System Parameters® Parameters®Message Waiting
Notification") will be displayed on the beeper's display instead. In either of these cases, if a caller's
telephone number is received through the telephone company's Caller ID service, the VPS will send
the caller's number to the beeper instead of the "System Callback No.".
Default
Disable
Value Range
Caller Select: After recording a message, the caller is asked whether or not he or she wishes to enter a callback
number.
Without: Without recording a message, the caller is asked to enter a callback number.
Before: Before recording a message, the VPS asks the caller to enter a callback number.
After: After recording a message, the VPS asks the caller to enter a callback number.
Disable: Disables the Callback Number Entry feature. Either the caller's telephone number received by through
the telephone company's Caller ID service or the "System Callback No." will be sent to the beeper.
Programming Manual References
"System Callback No." in 2.5.4.5 PBX Parameters
Feature Manual References
2.3.8 Calling a Beeper

Device Notification for Unreceived Message

This parameter determines what happens if Message Waiting Notification—Device begins but is interrupted
for some reason (i.e., the subscriber hangs up without listening to all new messages, the subscriber's mobile
phone disconnects while listening to messages, etc.).
If this parameter is set to "Yes", the VPS will try to call the lowest numbered device again. If this parameter is
set to "No", the VPS will call the lowest numbered device only after another new message is recorded in the
mailbox.
Default
No
Value Range
No, Yes
Feature Manual References
2.2.32 Message Waiting Notification—Device
Document Version 3.0 2010/06
2.1.4 Notification Parameters
Programming Manual 55