Service Mode - Panasonic KX-TVA50 Programming Manual

[Assigning Ports or Trunks to a Service Group]
1.
Select a Service Group Number (1–48) from the pull-down menu under Assign Group To.
To assign to a single port or a range of ports
1.
Click Port.
2.
Check Single Port or Range of Ports.
3.
Specify the desired port number or a range of port numbers (From:/To:).
To assign to a single trunk (CO line) or a range of trunks (CO lines)
1.
Click Trunk.
2.
Check Single Trunk or Range of Trunks.
3.
Specify the desired trunk (CO line) number or a range of trunk (CO line) numbers (From:/To:).
2.
Click Assign.
[Default Port/Trunk assignment]
Port 1-24 (KX-TVA200), 1-6 (KX-TVA50): Service Group No. 1
Trunk 1-64: None

Service Mode

Assigns one of 6 Service Modes to the Service Group.
Note
•
Once the Service Mode has been changed, it is retained unless the System Manager or System
Administrator changes it again, even after the power is turned off.
•
PBX Control mode is only available when the VPS is connected to a Panasonic KX-T series PBX using
APT/DPT Integration. If PBX Control mode is selected but cannot be used, the VPS will operate in
Automatic mode.
•
In Automatic mode, services have this order of priority:
Automatic Login (Toll Saver) > Holiday Service > Caller ID Call Routing> DID Call Routing > Trunk
Service> Port Service
•
In Manual modes (Day, Night, Lunch, or Break), services have this order of priority:
Automatic Login (Toll Saver) > Caller ID Call Routing> DID Call Routing >Trunk Service > Port Service
(Holiday Service is disregarded.)
Default
Automatic
Value Range
Automatic: The current Call Service used by the Service Group is determined by the settings made for the
current time mode (day, night, lunch, break).
Manual Day: The Call Service programmed for day mode is used, regardless of the current time mode.
Manual Night: The Call Service programmed for night mode is used, regardless of the current time mode.
Manual Lunch: The Call Service programmed for lunch mode is used, regardless of the current time mode.
Manual Break: The Call Service programmed for break mode is used, regardless of the current time mode.
PBX Control: The current Call Service used by the Service Group is determined by the settings made for the
current time mode (day, night, lunch, break). The VPS will change time modes according to when the PBX
changes time modes (APT/DPT Integration only).
Feature Manual References
2.4.6 Service Mode
Document Version 3.0 2010/06
2.3.1 Service Group
Programming Manual 93