Release Sequence For Call Waiting; Receiving Caller Id - Panasonic KX-TVA50 Programming Manual

Release Sequence for Call Waiting

Specifies the sequence for releasing Call Waiting.
Default
F
Value Range
Max. 16 digits consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause (default 1 s)
;: Dial Pause (default 3 s)
X: Extension Dialing
0–9, , #: Dial Code

Receiving Caller ID

Enables or disables the VPS to receive Caller ID from the PBX while receiving a call.
Default
Enable
Value Range
Disable, Enable
Waiting Time for Receiving Caller ID
Specifies the length of time that the VPS waits before receiving Caller ID from the PBX. This parameter is
needed only when "Enable" is selected in "Receiving Caller ID".
Default
0 s
Value Range
0 s–10 s
Inband Signaling
Set these parameters only if the Integration Mode is set to "Inband" under "PBX Environment". If the PBX type
is set to a KX-T series PBX, the Inband Signaling parameters will be automatically set to the default codes for
the KX-T series PBX.
Note
•
Default values below vary depending on the setting of "PBX Type" in "PBX Environment".
Ringback
Specifies the DTMF signal used to indicate a ringback tone. Sent to the VPS when the extension dialed is
ringing.
Document Version 3.0 2010/06
, # and special codes
2.5.4 Parameters
Programming Manual 157