Two-Way Recording Save Mode; Utility-Software Version; Utility-Lan Settings - Panasonic KX-TVA50 Programming Manual

2.
Select Commands.
(You can click the icon in the tool bar instead of step 1 and 2.)
3.
Enter "MAXL" (the quotation marks are not needed) and the desired value (e.g., MAXL 8), then press
ENTER.
•
The maximum length of mailbox numbers can be changed to 2–8 digits.
4.
Once the VPS reports that the maximum length of mailbox numbers has been changed, disconnect the
VPS by clicking Disconnect.
Note
•
You cannot change the maximum length of mailbox numbers to a number that is less than the
length of the current mailbox numbers.
•
To change the maximum length of mailbox numbers, you must first change the Mailbox No. Length
Mode to "Flexible" (see 1.9.11.1 Changing the Mailbox No. Length Mode). You cannot set the
maximum length of mailbox number to 6 or more digits when the Mailbox No. Length Mode is
"Fixed".

1.9.11.3 Two-way Recording Save Mode

By default, conversations recorded using the Two-way Recording feature are saved in the subscriber's mailbox
as old messages. However, it is possible to program the VPS to save these conversations as new messages,
rather than old, by entering a special command using the Commands dialog in the KX-TVA Maintenance
Console.
The Two-way Recording Save Mode setting is applied to a COS; all mailboxes assigned to the same COS will
have the same setting ("old" or "new"). To change the Two-way Recording Save Mode, follow the procedure
below.
1.
After you have started the KX-TVA Maintenance Console and connected to the VPS, select Utility in the
menu bar.
2.
Select Commands.
(You can click the icon in the tool bar instead of step 1 and 2.)
3.
Enter "TWRN" (the quotation marks are not needed), followed by the COS no. and "1" (e.g., TWRN 5,1),
then press ENTER.
•
Enter "1" after the COS no. to save conversations as new messages, and "0" to save conversations
as old messages (default).
4.
Once the VPS reports that the mode has been changed, disconnect the VPS by clicking Disconnect.
1.9.12 Utility—Software Version
Software Version is used to display the version of main software and DSP software for reference.
Follow the steps below to display the software version:
1.
Click Utility in the menu bar.
2.
Select Software Version.
3.
Click OK.
1.9.13 Utility—LAN Settings
The System Administrator can set the IP address and Port Number for the VPS. To program the VPS over
LAN connection or to use E-mail Integration features, the VPS must first be connected to the LAN and
programmed accordingly.
Document Version 3.0 2010/06
1.9.13 Utility—LAN Settings
Programming Manual 35