Change Drawer To Correct Paper Size" Is Displayed; Time For Periodic Maintenance" Is Displayed; Power Failure" Is Displayed; Erasing Data" Is Displayed - Toshiba E-STUDIO 2020AC Frequently Asked Questions Manual

9.QUESTIONS FOR ERROR MESSAGES
 "Change drawer to correct paper size" is displayed.
This may occur due to the following causes. Check them and take the appropriate actions.
 No paper suitable for the original is set.
Set the paper suitable for the original in the drawer.
 The size of the original is not detected correctly because the original is sent from the ADF at a skew.
Replace the original while aligning the side guides of the ADF to its width so that it will be placed straight.
 "Time for periodic maintenance" is displayed.
Inspection and maintenance by a service technician are required. Contact your service representative.
 "Power failure" is displayed.
A job was interrupted by a power failure or some other reason. The print or fax job may be incomplete. Press [Job
Status] to check whether any jobs are unfinished. To clear the messages, press the [FUNCTION CLEAR] button twice.
 "Erasing data" is displayed.
The Data Overwrite Enabler is clearing the data. This message is displayed if the Data Overwrite Enabler is installed.
The equipment can be operated while the message is being displayed.
 "Check paper size setting on control panel for Bypass. Check the direction or size of the
paper." is displayed.
Paper misfeed has occurred because of the mismatch between the paper size placed in the bypass tray and the size
registered for the bypass tray in the equipment. Just removing the misfed paper does not prevent another paper from
being misfed. Take the appropriate actions by following the reference below:
Troubleshooting - TROUBLESHOOTING FOR THE HARDWARE - Clearing a Paper Misfeed - Clearing paper
misfeeds caused by a wrong paper size setting
 "Misfeed in bypass." is displayed.
The paper placed on the bypass tray misfed. Remove the misfed paper. Then place the paper again.
 "Check the direction or size of the paper on the bypass tray and press START" is
displayed.
This may occur due to the following causes. Check them and take the appropriate actions.
 The direction or the size of the paper placed on the bypass tray is incorrect.
Check the direction and the size of the paper and then replace it on the bypass tray.
 The side guides of the bypass tray do not match the paper length.
Align the side guides of the bypass tray to the paper length.
 "Reboot the machine." is displayed.
A system-related error has occurred. Press the [POWER] button and then [Restart] on the touch panel.
Questions for Error Messages 61