Removing a DVD drive
To remove the DVD drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Pull the server out of the rack; then, remove the cover (see "Removing the
4. Disconnect the cables from the rear of the drive. You might also want to
5. Remove the two screws that secure the drive enclosure to the chassis.
6. Slide the drive enclosure toward the rear of the server slightly; then, lift the drive
7. Remove the four screws that secure the drive to the enclosure; then, remove
8. If you are instructed to return the DVD drive, follow all packaging instructions,
74
IBM System x3610 Type 7942: Problem Determination and Service Guide
on page 43.
external cables.
cover" on page 46).
disconnect the cables for the operator information panel and front Ethernet
connectors from the system board.
enclosure out of the server.
the drive from the enclosure.
and use any packaging materials for shipping that are supplied to you.