HP LASERJET ENTERPRISE M725dn Troubleshooting Manual page 481

First level
Scanner Settings
Serial Number
Service ID
Cold Reset Paper
New Registration Roller
PTT Test Mode
ENWW
Second level
ADF Simplex Count
ADF Duplex Count
Copy Scan Count
Send Scan Count
Fax Scan Count
Copy Pages Count
ADF Settings
Glass Settings
(fax models only)
Value Description
Set the total single-sided pages fed
through the document feeder.
Set the total two-sided pages fed
through the document feeder.
Set the total copy pages that have
been scanned.
Set the number of scanned pages
sent to email.
Set the number of scanned pages
that have been printed.
Leading- Set the calibration values.
edge
WARNING!
Trailing- these values unless instructed to do
edge so.
Left Side
Front
Left Side
Back
Leading
edge glass
Left Side
Glass
Set the serial number.
Use this item to show the date that
the product was first used on the
control panel. This eliminates the
need for users to keep paper
receipts for proof of warranty.
When you perform a cold reset,
the paper size that is stored in
NVRAM is reset to the default
factory setting. If you replace a
formatter board in a country/
region that uses A4 as the standard
paper size, use this menu to reset
the default paper size to A4.
LETTER and A4 are the only
available values.
Yes Reset the counter for the
registration roller after replacing
No
the registration assembly.
Test the internal modem for the
analog fax accessory.
Service mode functions
Do not change
449