Tray <X> Empty: [Type], [Size]; Tray <X> Open; Tray <X> Overfilled Remove Excess Paper; Tray <X> Overfilled To Use Another Tray, Touch "Options - HP LASERJET ENTERPRISE M725dn Troubleshooting Manual

NOTE:
This could be a false message. If the tray is loaded without removing the shipping lock, the
product does not sense that the paper is loaded. Remove the shipping lock, and then load the tray.
Tray <X> empty: [Type], [Size]
Description
The specified tray is empty and needs to be loaded, but the current job does not need this tray to print.
Recommended action
Refill the tray at a convenient time.
NOTE:
This could be a false message. If the tray is loaded without removing the shipping lock, the
product does not sense that the paper is loaded. Remove the shipping lock, and then load the tray.
Tray <X> open
Description
The specified tray is open or not closed completely.
Recommended action
1. Close the tray.
2. If this message appears and the lifter-base assembly was removed or replaced, make sure that the
connector on the assembly is correctly connected and fully seated.
3. If the error persists, use the paper size switches (SW2,3 - SW82,83 - SW92,93) test in the Tray/
Bin Manual Sensor Test to test the switches. If they do not respond, replace associated the
lifter drive assembly.
Tray <X> overfilled Remove excess paper
Description
A tray in the product is overfilled with paper. Printing can continue from a different tray.
Recommended action
Remove enough paper so that the paper stack does not exceed the limit for the tray.
NOTE: If this message appears and the paper-pickup assembly was removed or replaced, make sure
that the connector at the back of the assembly is correctly connected and fully seated.
Tray <X> overfilled To use another tray, touch "Options"
Description
Too much paper was loaded into the indicated tray.
Recommended action
Remove enough paper so that the paper stack does not exceed the limit for the tray or press the
Options button to use another tray.
394 Chapter 2 Solve problems ENWW