IES-1248-51 User's Guide
The following example removes a domain for a CPE device is connected to DSL port 1 on the
IES-1248-51 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI
35. The CPE device's LAN IP address is 10.10.10.10 and uses a subnet mask of
255.255.255.0. This includes the CPE device's LAN IP addresses and the IP addresses of the
LAN computers.
Figure 249 RPVC Route Delete Command Example
ras> adsl rpvc route delete 1 8 35 10.10.10.1/24
50.7.11 RPVC ARP Agingtime Set Command
Syntax:
ras> adsl rpvc arp agingtime set <sec>
where
<sec>
This command configures how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
The following example sets the device to store the IP addresses of CPE devices using 2684
routed mode in the Address Resolution Protocol table for 500 seconds.
Figure 250 RPVC ARP Agingtime Command Example
ras> adsl rpvc arp agingtime set 500
50.7.12 RPVC ARP Agingtime Show Command
Syntax:
ras> adsl rpvc arp agingtime show
This command displays how long the device stores the IP addresses of CPE devices using
2684 routed mode in the Address Resolution Protocol table.
356
The number of seconds (10~10000) the device is to keep the
=
Address Resolution Protocol table's entries of IP addresses of
CPE devices using 2684 routed mode. Use 0 to disable the aging
time.
Chapter 50 Virtual Channel Management