ZyXEL Communications IES-1248-51 User Manual page 70

IES-1248-51 User's Guide
Table 4 Web Configurator Screens (continued)
LABEL
ENET Port Setup
xDSL Port Setup
xDSL Profiles Setup
xDSL Line Data
Advanced
Application
VLAN
IGMP
Static Multicast
Filtering
MAC Filter
Spanning Tree
Protocol
Port Authentication
Port Security
DHCP Relay
2684 Routed Mode
Downstream
Broadcast
SysLog
Access Control
Routing Protocol
Static Routing
Alarm
Alarm Status
Alarm Event Setup
Alarm Port Setup
Management
Maintenance
Diagnostic
MAC Table
ARP Table
70
DESCRIPTION
Use this screen to configure settings for the Ethernet ports.
Use these screens for configuring settings for individual DSL ports.
Use these screens for configuring profiles for the DSL ports.
Use these screens for viewing DSL line operating values, bit allocation and
performance counters.
Use these screens for viewing and configuring the VLAN settings.
Use these screens to view IGMP status information and configure IGMP settings
and IGMP filters.
Use this screen to configure static multicast entries.
Use this screen to configure packet filtering.
Use this screen to configure MAC filtering for each port.
Use this submenu to go to screens for displaying Rapid Spanning Tree Protocol
(RSTP) information and configuring RSTP settings.
Use this submenu to go to screens for configuring RADIUS and IEEE 802.1x
security settings.
Use this screen to limit the number of MAC address that can be learned on a
port.
Use this screen to configure the DHCP relay settings.
Use this screen to configure the IES-1248-51 to handle 2684 routed mode
traffic.
Use this screen to block downstream broadcast packets from being sent to
specified VLANs on specified ports.
Use this screen to configure the syslog settings.
Use this screen to configure service access control and configure SNMP and
remote management.
Use this screen to configure static routes. A static route defines how the IES-
1248-51 should forward traffic by configuring the TCP/IP parameters manually.
Use these screens to view the alarms that are currently in the system.
Use these screens to view and set the severity levels of the alarms and where
the system is to send them.
Use this screen to set the alarm severity threshold for recording alarms on an
individual port(s).
Use this screen to perform firmware and configuration file maintenance as well
as restart the system.
Use this screen to view system logs and test port(s).
Use this screen to view the MAC addresses of devices attached to what ports.
Use this screen to view the MAC address to IP address resolution table.
Chapter 7 Introducing the Web Configurator