IES-1248-51 User's Guide
• In general deployment, the computer must set the CPE device's LAN IP address
(10.10.10.10 in this example) as its default gateway.
• The subnet range of any RPVC and RPVC domain must be unique.
Use the following command sequence to configure the IES-1248-51 for this example set up.
Figure 240 2684 Routed Mode Commands Example
ras> adsl rpvc gateway set 192.168.10.102 1
ras> adsl rpvc set 1 8 35 DEFVAL 192.168.10.200/32 192.168.10.102
ras> adsl rpvc route set 1 8 35 10.10.10.1/24
50.7.2 RPVC Gateway Set Command
Syntax:
ras> adsl rpvc gateway set <gateway ip> <vlan id> [<priority>]
where
<gateway ip>
<vlan id>
[<priority>]
This command adds a gateway IP address to use for 2684 routed mode traffic.
The following example has the device use a VLAN ID of 1 and IEEE 802.1p priority of 3
when sending 2684 routed mode traffic to a gateway at IP address 192.168.10.102.
Figure 241 RPVC Gateway Set Command Example
ras> adsl rpvc gateway set 192.168.10.102 1 3
50.7.3 RPVC Gateway Show Command
Syntax:
ras> adsl rpvc gateway show
This command displays the gateway IP addresses that are configured for use with 2684 routed
mode traffic.
350
The IP address of the gateway to which you want to send the
=
traffic that the system receives from this PVC. Enter the IP
address in dotted decimal notation.
The VLAN Identifier to add to Ethernet frames that the system
=
routes to this gateway.
Set the IEEE 802.1p priority (0~7) to add to the traffic that you
=
send to this gateway.
Chapter 50 Virtual Channel Management