This chapter shows you how to use the (standard shell) IP commands to configure the IP
(Internet Protocol) parameters.
46.1 IP Commands Introduction
Use the IES-1248-51's management IP addresses to manage it through the network.
46.2 IP Settings and Default Gateway
Use the following command sequence to set the IES-1248-51's IP settings for the Ethernet 1
and 2, and DSL ports, VID and default gateway. With the Ethernet 1 and 2, and DSL ports,
you must connect to the IES-1248-51 through a port that is a member of the management
(CPU) VLAN in order to perform in-band management.
Figure 164 IP Settings and Default Gateway Address Commands
ras> ip set <new ip address> [</netmask>]
ras> ip gateway <ip>
ras> config save
where
<new ip
address>
</netmask>
<ip>
The first command changes the IP settings for the IES-1248-51's uplink, downlink and IES-
1248-51 DSL ports. If you don't enter the subnet mask, the system automatically computes the
subnet mask.
Chapter 46 IP Commands
C
IP Commands
The IP address you want to configure for the IES-1248-51.
=
The bit number of the subnet mask of the IP address you want to
=
configure for IES-1248-51's uplink, downlink and IES-1248-51
DSL ports. To find the bit number, convert the subnet mask to
binary and add all of the 1's together. Take "255.255.255.0" for
example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number
(24).
The default gateway IP address you want to configure for the
=
IES-1248-51.
IES-1248-51 User's Guide
H A P T E R
4 6
287