Adsl Profile Set Command; Figure 185 Adsl Profile Show Command Example - ZyXEL Communications IES-1248-51 User Manual

The following example displays the ADSL DEFVAL profile.

Figure 185 ADSL Profile Show Command Example

ras> adsl profile show DEFVAL
01. DEFVAL
max rate
min rate
latency delay (ms):
max margin
min margin
target margin (db):
up shift margin(db):
down shift margin(db):

49.1.5 ADSL Profile Set Command

Syntax:
ras> adsl profile set <profile> <fast|interleave[=<up delay>,<down delay>]>
<up max rate> <down max rate>
[<up target margin> <up min margin> <up max margin> <up min rate>
<down target margin> <down min margin> <down max margin> <down min rate>
<up down-shift margin> <up up-shift margin>
<down down-shift margin> <down up-shift margin>]
where
<profile>
<fast|interleav
e[=<up
delay>,<down
delay>]>
<up max rate>
<down max rate> =
<up target
margin>
<up min margin> =
<up max margin> =
<up min rate>
Chapter 49 ADSL Commands
latency mode: interleave
up stream down stream
--------- -----------
(kbps): 512
(kbps): 32
4
(db): 31
(db): 0
6
9
3
The descriptive name for the profile.
=
The latency mode. With interleave, you must also define the
=
upstream and downstream delay (1-255 ms). It is recommended
that you configure the same delay for both upstream and
downstream.
The maximum ADSL upstream transmission rate (64-4096
=
Kbps).
The maximum ADSL downstream transmission rate (64-32000
Kbps).
The target ADSL upstream signal/noise margin (0-31db).
=
The minimum acceptable ADSL upstream signal/noise margin
(0-31db).
The maximum acceptable ADSL upstream signal/noise margin
(0-31db).
The minimum ADSL upstream transmission rate (32-3000
=
Kbps).
IES-1248-51 User's Guide
2048
32
4
31
0
6
9
3
305