The following example sets the default VID of port 1 to 200.
Figure 133 VLAN PVID Command Example
ras> switch vlan pvid 1 200
42.4.3 VLAN Priority Command
Syntax:
ras> switch vlan priority <portlist> <priority>
where
<portlist>
<priority>
This command sets the priority of incoming frames with an IEEE 802.1Q VLAN tag.
The following example sets a priority of three for frames (with an IEEE 802.1Q VLAN tag)
that come in on ADSL port 2.
Figure 134 VLAN CPU Set Command Example
ras> switch vlan priority 2 3
42.4.4 VLAN Set Command
Syntax:
ras> switch vlan set <vid> <portlist>:<F<T|U>|X|N> [<portlist>:<F<T|U>|X>
...][name]
where
<vid>
<portlist>
Chapter 42 IEEE 802.1Q Tagged VLAN Commands
You can specify a single port: <1>, all ports: <*>, a list of ports:
=
<1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,enet2>.
This is the priority value (0 to 7) to use for incoming frames
=
with an IEEE 802.1Q VLAN tag.
The VLAN ID [1 – 4094].
=
You can specify a single port: <1>, all ports: <*>, a list of ports:
=
<1,3,enet1>, you can also include a range of ports:
<1,5,6~10,enet1,enet2>.
IES-1248-51 User's Guide
265