Route Set Command; Route Delete Command; Route Show Command - ZyXEL Communications IES-1248-51 User Manual

46.3.3 Route Set Command

Syntax:
ras> ip route set <dst ip>[/netmask] <gateway ip> [metric] <name>
ras> ip route set default
where
<dst ip>
[/netmask]
<gateway ip>
[metric]
<name>
default
This command defines a new, static IP forwarding route or edits an existing one.

46.3.4 Route Delete Command

Syntax:
ras> ip route delete <dst ip>[/netmask]
where
<dst ip>
[/netmask]
This command removes a static, IP forwarding route.

46.3.5 Route Show Command

Syntax:
ras> ip route show
This command displays the IES-1248-51's routing table.
Chapter 46 IP Commands
<gateway ip> <metric>
The destination IP address of packets that this static route is to
=
route.
The destination subnet mask of packets that this static route is to
=
route.
The IP address of the gateway that you want to send the packets
=
through.
The metric (hop count) of this static route.
=
A name to identify this static route. Up to 31 ASCII characters.
=
Spaces and tabs are not allowed.
Use this to configure the IES-1248-51's default route.
=
The destination IP address of packets to which this static route
=
applies.
The destination subnet mask of packets to which this static route
=
applies.
IES-1248-51 User's Guide
289