V.25Bis Command Set - ZyXEL Communications U-336S User Manual

or using the PANEL LOCK menu from the panel, or by issuing the
AT*L1 command from the terminal. Issuing the AT*L0 command
will return the key operation to normal. Alternatively, pressing the
left and right arrow keys simultaneously will unlock the panel. In
locked panel mode, the ENTER key will lose its effectiveness in
changing or saving settings; panel command execution is also
disabled. However, viewing in the panel is not affected.
This chapter introduces you to the use of the U-336S for
synchronous operation. The modem can be used as a synchronous
modem when it is connected to a synchronous computer or
terminal. It is of course necessary to make sure that the remote
modem and system are also set to synchronous mode. Synchronous
operation applies to all of the non-FSK modes the modem is
supplied with. Before synchronous transfers are started, some initial
settings should be made.

V.25bis Command Set

To enable V.25bis commands use the AT*I1 command.
For synchronous applications, the modem is permanently set in
normal situations for use with one application. Save the desired
settings in the power-on profile, and the modem will be initialized
to synchronous mode (&M3) with V.25bis command enabled (*I1)
when powered on.
A special command RST is provided to get the modem back to
asynchronous AT command mode from V.25bis mode. You can
enter this RST command in either synchronous or asynchronous
V.25bis mode.
Syntax Command with
CRN
38 LCD Panel Operation
Description
Parameters*
CRN Call request with number provided.
<dialstring>**