Lineinfo Command; Figure 213 Lineinfo Command Example - ZyXEL Communications IES-1248-51 User Manual

49.2.3 Lineinfo Command

Syntax:
ras> statistics adsl lineinfo <portlist>
where
<portlist>
This command shows the line operating values of an ADSL port.
An example is shown next.

Figure 213 Lineinfo Command Example

ras> statistics adsl
[port 8]
operating modes:
- service type in operation: adsl2+
- TRELLIS operation mode
connection detail:
- down/up stream interleaved delay (ms):
- total transceiver DS output power
- total transceiver US output power
atuc information:
- vendor id:
- version number: 66323330323030300000000000000000
- serial number :
30323030306530336539303030370000000000000000000000000000000000
00
atur information:
- vendor id:
- version number: 41327042303139610000000000000000
- serial number :
0000000000000000000000000000000000000000000000000000000000000000
The service type in operation is the ADSL standard that the port is using: G.dmt or ANSI
T1.413 issue 2.
Trellis coding helps to reduce the noise in ADSL transmissions. Trellis may reduce throughput
but it makes the connection more stable.
4. At the time of writing, the IES-1248-51 always uses Trellis coding.
Chapter 49 ADSL Commands
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
lineinfo 8
: on
(dbm): -2.5
(dbm): 11.5
30304235303035300000000000000000
b5004244434d00000000000000000000
4
IES-1248-51 User's Guide
3/ 2
321