IES-1248-51 User's Guide
where
<portlist>
This command forcibly enables the specified ADSL port(s).
49.1.3 ADSL Disable Command
Syntax:
ras> adsl disable <portlist>
where
<portlist>
This command forcibly disables the specified ADSL port(s).
Note: The factory default of all ports is disabled. A port must be enabled before data
transmission can occur. An enabled but disconnected ADSL port generates
more heat than an operating port. To minimize heat generation and to enhance
reliability, remember to disable a port when it is not in use.
49.1.4 ADSL Profile Show Command
Syntax:
ras> adsl profile show [profile]
where
<profile>
This command displays the specified ADSL profile or all ADSL profiles if you do not specify
one.
304
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
You can specify a single ADSL port <1>, all ADSL ports <*>
=
or a list of ADSL ports <1,3,5>. You can also include a range of
ports <1,5,6~10>.
A profile name.
=
Chapter 49 ADSL Commands