where
<accept|deny>
This command sets whether the IES-1248-51 allows or blocks access for the MAC addresses
you specify.
The following example sets ADSL port 5 to allow frames from the MAC addresses specified
for ADSL port 5.
Figure 146 MAC Filter Mode Command Example
ras> switch mac filter mode 5 accept
43.2.5 MAC Filter Set Command
Syntax:
ras> switch mac filter set <port> <mac> [<mac> <mac> ...]
where
<port>
<mac>
This command adds an allowed source MAC address on the specified ADSL port.
The following example adds source MAC address 00:a0:c5:12:34:56 for ADSL port 5.
Figure 147 MAC Filter Set Command Example
ras> switch mac filter set 5 00:a0:c5:12:34:56
43.2.6 MAC Filter Delete Command
Syntax:
ras> switch mac filter delete <port> <mac> [<mac> <mac> ...]
where
<port>
Chapter 43 MAC Commands
accept = Only allow frames from MAC addresses that you
=
specify and block frames from other MAC addresses.
deny = Block frames from MAC addresses that you specify and
allow frames from other MAC addresses.
The number of an ADSL port.
=
The source MAC address in "00:a0:c5:12:34:56" format.
=
The number of an ADSL port.
=
IES-1248-51 User's Guide
273