Saving Your Configuration; Commands; Table 70 Commands - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51 User's Guide

38.3 Saving Your Configuration

Use the following command to save your configuration when you are done with a
configuration session.
ras> config save
Note: Do not turn off your IES-1248-51 while saving your configuration.
This command saves all system configurations to nonvolatile memory. You must use this
command to save any configuration changes that you make, otherwise the IES-1248-51
returns to its default settings when it is restarted. Save your changes after each configuration
session.
Nonvolatile memory refers to the IES-1248-51's storage that remains even if the IES-1248-
51's power is turned off. Run-time (memory) is lost when the IES-1248-51's power is turned
off.

38.4 Commands

The following table lists commands that you can use with the IES-1248-51.
The P column on the right indicates the administrator privilege level needed to use the
command (H for high, M for middle or L for low) and the equivalent in the web configurator
(H for high or L for low).

Table 70 Commands

CLASS COMMAND
sys
info show
info hostname
info location
info contact
reboot
snmp show
snmp getcommunity
snmp setcommunity
snmp trapcommunity
226
PARAMETERS
<hostname>
<location>
<contact>
[show|sec|cancel]
<community>
<community>
<community>
DESCRIPTION
Displays general system
information.
Sets the system name.
Sets location information.
Sets contact person information.
Sets the reboot timer or displays
the timer and remaining time for
reboot. If a reboot has been
scheduled, use this command to
prevent a reboot.
Displays SNMP settings.
Sets the SNMP GetRequest
community.
Sets the SNMP SetRequest
community.
Sets the SNMP Trap community.
Chapter 38 Commands
P
L/L
M/L
L/L
L/L
H/H
M/L
H/H
H/H
H/H