6
Power supply units
Safety notes
V
CAUTION!
Do not disassemble the power supply unit. Doing so may cause
●
electric shock.
Areas around the power supply unit may remain extremely hot after
●
shutdown. After shutting down the server, wait for hot components to
cool down before removing the power supply unit.
When installing a power supply unit, ensure that the connector of the
●
power supply unit is not damaged or bent.
If the power supply unit is hard to remove, do not pull it out by force.
●
The power supply unit is heavy, so handle it carefully. If you drop it by
●
mistake, injuries may result.
For further safety information, please refer to chapter
●
information" on page
6.1
Basic information
The PRIMERGY RX2540 M1 server can be equipped:
– with up to two power supply units that automatically adjust to any mains
voltage in the range of 100 VAC - 240 VAC
I
For 800 W (Titanium) power supply unit:
Mains input voltage range: 200 VAC – 240 VAC
I
Power redundancy is possible with two power supply units. The effective
power of the power supply units may not differ.
V
CAUTION!
The server supports a mains voltage in the range of 100 VAC - 240 VAC.
You may only operate the server if its rated voltage range corresponds to
the local mains voltage.
RX2540 M1
39.
Upgrade and Maintenance Manual
"Important
101