Concluding Steps - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Figure 163: Inserting the DynamicLoM module
Ê Install the DynamicLoM module with the bottom side above.
I
For DynamicLoM D3275:
Remove the protective foil.
Ê Fasten it with the three screws on the bolts (M3x 4.5 mm).
9.8.2.4

Concluding steps

"Reassembling" on page 61
Ê
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 93.
"Updating the NIC configuration file in a Linux environment" on page 90
Ê
"Configuring LAN teaming" on page 97
Ê
"Enabling SVOM boot watchdog functionality" on page 86
Ê
Ê Start Emulex PXESelect Utility
RX2540 M1
"Looking up changed MAC / WWN addresses"
Upgrade and Maintenance Manual
Expansion cards and backup units
257