Installing The System Air Duct; Concluding Steps; Installing A Gpgpu Card In Riser Module 2; Preliminary Steps - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê Install the riser module as described in section
(FL)" on page
9.6.2.8

Installing the system air duct

I
If no GPGPU card is installed you have to order a new air duct to direct
the airflow directly onto the CPU heat sinks and memory slots.
Ê Install the system air duct as described in section
page 61.
9.6.2.9

Concluding steps

"Reassembling" on page 61
Ê
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling BitLocker functionality" on page 92
Ê
9.6.3

Installing a GPGPU card in riser module 2

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.6.3.1

Preliminary steps

"Disabling or suspending BitLocker functionality" on page 69
Ê
"Disabling SVOM boot watchdog functionality" on page 70
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting power cords" on page 54
Ê
"Getting access to the component" on page 55
Ê
224
214.
Upgrade and Maintenance Manual
"Installing the riser module 1
"Installing the air duct" on
Hardware: 5 minutes
Software: 5 minutes
RX2540 M1