Installing A Gpgpu Card In A Riser Module (Fl); Replacing The Heat Sink (Fl); Removing The Slot Cover (Riser Module 1) - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

9.6.1.4

Installing a GPGPU card in a riser module (FL)

Figure 115: Installing a GPGPU card in a riser module
Ê Carefully insert the GPGPU card into the desired PCI slot and press down
firmly until it is fully seated in the slot.
Ê Fasten the GPGPU card with two screws.
9.6.1.5

Replacing the heat sink (FL)

Ê Replace the standard processor heat sink with the processor heat sink for
GPGPU as described in section
page 312.
9.6.1.6

Removing the slot cover (riser module 1)

Ê Remove the slot cover as described in section
(riser module 1)" on page
RX2540 M1
"Replacing processor heat sinks" on
188.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing the slot cover
213