Table of Contents
Advertisement
Expansion cards and backup units
Ê If applicable, install the riser module 2 as described in section
riser module 2 (FL)" on page
9.6.6.4
Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
9.6.6.5
Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the GPGPU card (riser module 1) as
described in section
Ê If applicable, connect a FBU to the GPGPU card (riser module 1) as
described in section
9.6.6.6
Concluding steps
"Reassembling" on page 61
Ê
Ê Reconnect all external cables to the replaced expansion card.
"Connecting the server to the power source" on page 66
Ê
"Switching on the server" on page 67
Ê
"Enabling replaced components in the system BIOS" on page 86
Ê
Ê If
applicable,"Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 86
Ê
"Enabling BitLocker functionality" on page 92
Ê
9.7
Backup Units
9.7.1
Basic information
The Flash Backup Unit (FBU) backs up the memory contents of the connected
SAS RAID controller in the event of a power failure. The PRIMERGY
RX2540 M1 server can accommodate up to two backup units.
236
226.
411.
"Installing the FBU" on page
"Installing the FBU (riser module 2)" on page
Upgrade and Maintenance Manual
"Installing the
"List of used
216.
229.
81.
RX2540 M1
Advertisement
Table of Contents
